[ previous ] [ next ] [ threads ]
 
 From:  David Moron <david dot moron at openwired dot net>
 To:  m0n0wall at lists dot m0n0 dot ch
 Subject:  Re: [m0n0wall] PPTP Problem
 Date:  Wed, 12 Jul 2006 15:18:40 +0200
I defined "pass all rules" in LAN and WAN interfaces but I'm still
unable to access the LAN :-(


> Try a LAN rule to allow PPTP clients access to LAN subnet? Im pretty sure
> thats what I had to setup. Set it up as * * * * and then start playing with
> specific access thru certain ports etc
> 
> JK
> 
> -----Original Message-----
> From: David Moron [mailto:david dot moron at openwired dot net]
> Sent: Wednesday, 12 July 2006 6:11 PM
> To: m0n0wall at lists dot m0n0 dot ch
> Subject: [m0n0wall] PPTP Problem
> 
> 
> Hi,
> 
> I'm using monowall 1.22 and I'm trying to configure the PPTP access.
> I can connect via PPTP to monowall correctly, I can browse through the
> PPTP tunnel but I can't access the LAN workstations.
> 
> All the traffic is allowed in the PPTP interface
> 
> PPTP VPN Rules:
> Proto Source Port Destination Port
> *     *      *    *           *
> 
> LAN IP: 192.68.0.254 (I know it's a public address but I'm not allowed
> to change it)
> 
> PPTP Config:
> Enable PPTP Server
> Server Address: 192.68.0.208
> Remote Address Range: 192.68.0.192/28
> 
> Traceroute from the PPT Client to 192.68.0.99 suceess only to the first
> hop 192.68.0.208.
> 
> Ping to the PPTP client IP from monowall on the LAN interface reports:
> "ping: sendto: No route to host"
> 
> Ping to the LAN workstation 192.68.0.99 from monowall works OK.
> 
> ipconfig on the PPTP client:
> PPP Adaptor:
> 	IP: 192.68.0.192
> 	mask: 255.255.255.255
> 	gateway: 192.68.0.192
> 
> Has anyone an idea whats happening?
> 
> Thak you in advance,
> 
> --

> 
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch

--