If you mean under WAN config untick block private networks, then yes I 
have done that.

I also see the firewall allowing the connection in the logs.

Melvin wrote:

> Did you remember to enable routing of private IPs?  They are disabled 
> by default.
>
>
> Kevin Blanc wrote:
>
>> Hi
>>
>> I am trying to setup 1:1 NAT like so
>> 10.0.0.34/8(address for clients to connet)---NATed 
>> to---192.168.6.8/23(server address) I have entered a firewall rule to 
>> allow ssh to the 192 addr, and also setup proxy arp for the 10 addr.
>>
>> I have this working fine on an older version of  m0n0wall the only 
>> differance is the address clients connect to is a public ip 194.*.*.*
>>
>> Kev
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
>> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>>
>>
>