[ previous ] [ next ] [ threads ]
 
 From:  Dennis Wallberg <dman at shell dot linux dot se>
 To:  Dennis Wallberg <dman at shell dot linux dot se>
 Cc:  m0n0wall at lists dot m0n0 dot ch
 Subject:  Re: [m0n0wall] i3 micro vood 322 NAT problem
 Date:  Mon, 24 Jul 2006 09:03:03 +0200
No ideas? anyone? is it possible to turn off SPI?

/Dennis

Dennis Wallberg skrev:
> Hi all!
>
> I recently got this new vood box, i3 micro vood 322. I have some 
> problems with this device so I turn to the m0n0 list for comments
>
> first of all I use m0n0 generic PC v1.2 on a CF-card
>
> Since my ISP only give me one IP I have to connect the vood on my lan 
> side. The vood has built in FW, NAT, ipfilter rules and bridge 
> functions etc. here's the manual 
> http://www.static.tele2.se/editorial/SE-SE//m/manual_bbtlf_router.pdf 
> . All of these functions are of less interest for me because Im quite 
> happy with my current m0n0 setup. After making some NAT & FW rules in 
> m0n0 and turned off the FW in the vood322 I was finally able to make 
> an outgoing call, however I (or someboty else for that matter) can not 
> call me.
>
>
> The ports forwarded to the vood322 is
> NAT rules:
> WAN TCP/UDP ext range 5060-5061 same internal port range
> WAN TCP/UDP ext reange 10000-10007 same internal port range
>
> FW rules :
>
> *   *   *   'voodIP' *
>
> I tried to use only UDP and TCP/UDP in the NAT section and the same in 
> rules section on m0n0, how I use any protocol in rules. Theese are the 
> ports specified to be used.
>
> Is there a way to solve this, can I turn off stateful packet 
> inspection on certain rules (the VoIP SIP rules) ? As this might be a 
> problem.
>
> Best regards
> Dennis
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>