Try running pfsense on the board.  Its likely that your WLG500 has too 
new a chipset to be supported by the 1.2b7 (FreeBSD 5.x based) image.   
pfSense is FreeBSD 6.1-based.

If it works on pfSense, but not monowall 1.2b7, then you'll either have 
to run one of the 6.1-based m0n0wall "beta" images, run pfSense, wait 
for m0n0wall to officially be based on 6.1, or "roll your own".

If you're running a m0n0wall image outside the 1.2b5 - 1.2b7 range 
**including** the 1.22/1.23bX series (and its not one of the 6.1-based 
'alpha/beta' images), then the problem is ... obvious.   FreeBSD 4.11 
didn't support *any* 802.11a or 802.11g cards.

Jim

Mark Phillips wrote:
> Hi Chris et al,
>
> I have a model WLG500-3B 802.11a/b/g card
>
> There is no 4th interface in the gui either.
>
> Mark
>
> On Mon, 2006-07-31 at 13:44 -0400, Chris Buechler wrote:
>   
>> On 7/31/06, Mark Phillips <g7ltt at g7ltt dot com> wrote:
>>     
>>> I have checked that the card works by putting it into my laptop - all
>>> ok. When installed into my WRAP I expected to see an extra port listed
>>> on the console but all I see is the 3 SISx ports.
>>>
>>>       
>> When you go to assign interfaces in the GUI, it only shows 3 sis ports
>> as well?  What's the exact card you have?
>>
>> -Chris
>>
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
>> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>>
>>
>>
>>     
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>