[ previous ] [ next ] [ threads ]
 From:  "Chuck Mariotti" <cmariotti at xunity dot com>
 To:  "Joseph Lo" <josephlo71 at yahoo dot com>, <m0n0wall at lists dot m0n0 dot ch>
 Subject:  RE: [m0n0wall] FTP server behind monowall
 Date:  Sat, 9 Sep 2006 11:02:40 -0400
Not sure where you are or if it is applicable since you tried shields
up... but I ran into a problem setting up an FTP server on a friends
cable modem a few years back. Couldn't figure it out. Turned out his
cable provider was blocking FTP.... They also blocked SMTP, etc...
Wasted a whole evening trying to figure out why it wasn't working. Might
be worth verifying FTP is not disabled by the ISP.



-----Original Message-----
From: Joseph Lo [mailto:josephlo71 at yahoo dot com] 
Sent: Saturday, September 09, 2006 7:34 AM
To: m0n0wall at lists dot m0n0 dot ch
Subject: [m0n0wall] FTP server behind monowall

Dear All,

I know this is an age old question: how to setup ftp server behind

I have searched the forum and read the monowall scratchpad. But I still
can't get my ftp server to work. I am hoping someone could enlighten me.

Here is my setup.

internet ----> monowall ----> switch ----> ftp server

monowall is
ftp server is I am using FileZilla on windows XP as some
have suggested.

Here are my monowall config

Firewall NAT Inbound
lf            proto     Ext. port range        NAT IP        Int. port
range        Description
WAN    TCP            20                  
20                ftp server port 20
WAN    TCP            21                 
21                ftp server port 21
WAN    TCP        55000-61000      55000-61000
ftp server

Firewall NAT outbound
Interface        source                Destination        Target
WAN            *        ftp server

Firewall rules
Proto        Source            Port        Destination        Port
TCP            *                       *         21
FTP server 1
TCP            *                        *  
55000-61000        FTP server 2

I have setup filezilla with passive mode settings External server IP
address for passive mode transfer -> use the following IP ->

I have also checked the tick box
* Don't use external IP for local connections
* use custom port range: 55000 - 61000

When I use ftp client to connect to it work. When I use ftp
client from external lan to connect to my dynamic IP, it can't find the
ftp server. by the way, I am using monowall's dyndns server. Pinging my
hostname (eg. hostname.homeunix.net) from the net work. 

I have use Shield-up to check and it report that port 21 is open.

I have tried many configuration and still can't get anything to work. 

Please help

Thank  you.

Get your own web address for just $1.99/1st yr. We'll help. Yahoo! Small
How low will we go? Check out Yahoo! Messenger's low  PC-to-Phone call