|
||||||||
I use Packet8, so it may not be the same, but only until last week FAX lines were not supported. Could be related...data/modem transmissions may not be reliable over Vonage's VoIP network until they specifically support it. -Kyle -----Original Message----- From: Richard Deno [mailto:draco dot red at gmail dot com] Sent: Thursday, September 14, 2006 9:47 AM To: m0n0wall at lists dot m0n0 dot ch Subject: [m0n0wall] Trouble with VoIP and AC Nielsen's Homescan consumer panel A bit after I switched for DSL to cable (8Mb down, 1.5Mb up--w00t!), I also switched my phone service to Vonage. Good price, but I've been having some problems with sound quality. Half the time when we are talking to someone they say that it sounds like we are talking under water, and we've been having some trouble transmitting from our Homescan handheld device. For those who don't know (most everyone) AC Nielsen (the same people who do TV ratings) have a program called the "Homescan Consumer Panel". In this they send you a handheld bar code scanner, and you scan everything that you buy. On the body of the scanner there is an acoustic coupler speaker cup, and to transmit you call their 800 number, press the speaker against the phone's microphone and press OK. It than makes a standard modem type connection, and transmits all the data that it has collected since it last transmitted. We usually don't have a problem with transmitting, but lately we just haven't been able to get the data through. At first I thought it was because a Bit-Torrent client was running on our network, but even with all the computers turned off, we still can't get it through. I already have traffic shaper going, but I was wondering if it would be possible to partition off a specific amount of bandwidth for the Vonage adapter itself? I have the call quality set at 90 Kbps and Vonage is heavily preferred (weighted at 100 with the highest anything else being at 13). Any suggestions would be great--I'll send out my config file in the next two e-mails (30000 bytes limit). Thanks-- Richard |