On 9/30/06, Robert Fitzpatrick <lists at webtent dot net> wrote:
> I am brand new to m0n0wall, I use FreeBSD quite a bit and decided to
> consider m0n0wall to be my router. I tried a Sonicwall and it was not
> compatible with my network setup I guess. Although I've managed many
> firewalls in the past, my networking knowledge is limited without formal
> training, perhaps I need that for what I am trying to do.
> OK, I have 3 subnets assigned by the provider including the WAN subnet,
> I guess I should use fictitious public numbers for privacy reasons? I'll
> leave the last octet true and match the other octets where applicable.
> This is what I would like to setup:
> 111.222.333.96/29 - WAN assigned by provider
> 444.55.666.0/26 - usable subnet
> 111.222.777.0/27 - usable subnet
> So, my question is whether m0n0wall can handle all of these public
> networks all on the same device with 4 eth ports using the OPT1 & 2 for
> the two usable subnets? And using LAN for my own NAT as well? Is all
> that possible?
> If so, what docs should I be ready in order to understand what I need to
> do as well as set it up?
> Thanks in advance for any help!
m0n0 does not handle this. You could try using 3 m0n0 machines (1 for
each WAN subnet) or there is a m0n0 fork at pfsense.org that can
handle multiple WAN interfaces.