Thanks.... it works fine with proxy arp and server nat!

Now I got another problem, I tried to use the outbound nat but i can't
get it working.
My config looks like this:

Interface	Source		Destination	Target
WAN	10.0.0.0/24	*		80.160.xxx.77

Isn't that right??	

-----Original Message-----
From: Lee Sharp [mailto:leesharp at hal dash pc dot org] 
Sent: 23. november 2006 17:01
To: m0n0wall at lists dot m0n0 dot ch
Subject: Re: [m0n0wall] Routing WAN addresses

From: "Mikkel Robin Nielsen" <MRN at dansupport dot dk>

> And then I have a WAN segment 

> 80.160.xxx.76/30

Look at server NAT, and possable proxy arp.

> Then I need to route the 80.160.xxx.77 to my DMZ 192.168.10.0/24
> And 80.160.xxx.78 to my LAN 10.0.0.0/24

This is NATing, not routing.

                                Lee

---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch