>Original-Recipient: rfc822;s dot osterling at telia dot com
>Mailing-List: contact m0n0wall dash help at lists dot m0n0 dot ch; run by ezmlm
>X-No-Archive: yes
>List-Post: <mailto:m0n0wall at lists dot m0n0 dot ch>
>List-Help: <mailto:m0n0wall dash help at lists dot m0n0 dot ch>
>List-Unsubscribe: <mailto:m0n0wall dash unsubscribe at lists dot m0n0 dot ch>
>List-Subscribe: <mailto:m0n0wall dash subscribe at lists dot m0n0 dot ch>
>Delivered-To: mailing list m0n0wall at lists dot m0n0 dot ch
>From: "Lee Sharp" <leesharp at hal dash pc dot org>
>To: <m0n0wall at lists dot m0n0 dot ch>
>Date: Thu, 18 Jan 2007 22:01:57 -0600
>X-Mailer: Microsoft Outlook Express 6.00.2900.3028
>Subject: Re: [m0n0wall] Installation on PC/IDE HD  generic-pc-1.22.img
>X-NAS-Language: English
>X-NAS-Bayes: #0: 0; #1: 1
>X-NAS-Classification: 0
>X-NAS-MessageID: 2006
>X-NAS-Validation: {DCB5C83A-78A1-4194-B836-D8686FD6CD37}
>
>From: "Staffan Österling" <s dot osterling at telia dot com>
>
>>Problem: Message "Read error"  at booting after installation of
>>generic-pc-1.22.img
>>HW: PC 100MHz, 80Mb IDEHD (hda), No CD
>>Process: Using TomsRTBT to boot in Linux  etc according to instruction.
>>Downloading, dd etc runs without errors.
>
>>Rebooting gives "Read error"
>
>Most common reason for this is writing the image to a partition, not a 
>disk. Make sure you are writing to the entire device, not just a slice of 
>the device.
>
>                                Lee
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
>For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>

Tried writing to hda1 before. Writing to /dev/hda.
Checked with fdisk /dev/hda
/dev/hda4    * 1   4   25000  a5   FreeBSD

Read error after rebooting - as before

/Staffan