I upgraded from 1.2x to 1.3b2 on an IP110 (16 Meg CF card) and it failed.

Any idea if it will work in the future or is it a limitation of the hardware?

thanks,
tom

---------------------------------------


I've included the following in case it helps anyone come up with a solution:

Copyright (c) 1992-2006 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 6.2-RC1 #0: Sat Dec 23 16:41:48 CET 2006
    root at mb62 dot neon1 dot net:/usr/src/sys/i386/compile/M0N0WALL_GENERIC
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Geode(TM) Integrated Processor by National Semi (266.68-MHz 586-class CPU)
  Origin = "Geode by NSC"  Id = 0x540  Stepping = 0
  Features=0x808131<FPU,TSC,MSR,CX8,CMOV,MMX>
real memory  = 67108864 (64 MB)
avail memory = 43696128 (41 MB)
wlan: mac acl policy registered
ath_hal: 0.9.17.2 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
cpu0 on motherboard
pcib0: <Host to PCI bridge> pcibus 0 on motherboard
pir0: <PCI Interrupt Routing Table: 3 Entries> on motherboard
pci0: <PCI bus> on pcib0


Fatal trap 12: page fault while in kernel mode
fault virtual address   = 0xeb11f
fault code              = supervisor read, page not present
instruction pointer     = 0x20:0xc00eb621
stack pointer           = 0x28:0xc1820a54
frame pointer           = 0x28:0xc1820a54
code segment            = base 0x0, limit 0xfffff, type 0x1b
                        = DPL 0, pres 1, def32 1, gran 1
processor eflags        = interrupt enabled, resume, IOPL = 0
current process         = 0 (swapper)
trap number             = 12
panic: page fault
Uptime: 1s
Automatic reboot in 15 seconds - press a key on the console to abort
--> Press a key on the console to reboot,
--> or switch off the system now.