You need to use a certificate that doesn't have a password protected private
key.

Remove the password, upload the certificate again and try again, it'll work.
There's no need to change fw rules to allow HTTPS

Kind Regards,

J.

> -----Oorspronkelijk bericht-----
> Van: Tobias Jarmuzek [mailto:petite underscore conne at shared dash folder dot com]
> Verzonden: dinsdag 13 februari 2007 14:58
> Aan: m0n0wall at lists dot m0n0 dot ch
> Onderwerp: Re: [m0n0wall] HTTPS-User-Login
> 
> 
> > It's been a while since I set up my CP, but don't you need a fw rule
> > allowing traffic to the CP, i.e. 8001/tcp? I seem to remember similar
> > problems and I still see a rule in my fw on OPT1 that allows any
> > traffic to port 8001/tcp to the OPT1 IP of m0n0. iirc, this was was
> > did the trick, but someone who has actually helped code the CP might
> > know more details and I am just talking out of my ass, as usual. :)
> >
> > Sven
> >
> I have now created such a fw rule but nothing has changed. There is
> still the same problem.
> The host https://192.168.40.1:8001/?redirect=..... is not reachable.
> I found out that i have no certificate and key in my webgui - ssl
> options. Could that be
> a problem? But the webguis-ssl connection works ...?
> 
> Toby
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch