I don't have much experience with the Net45xx (or any Soekris product 
for that matter). But i've had some CF trouble on a WRAP platform. Turns 
out the PC i was writing the image from was not detecting the drive 
geometry properly. (C/H/S). And the WRAP couldn't read the CF properly.

Can't say this is your problem but you might want to manually specify 
the CHS in your BIOS.

James W. McKeand wrote:
> Troels Månsson Kaspersen wrote:
>   
>> The output from Soekris says:
>>
>> comBIOS ver. 1.29  20070204  Copyright (C) 2000-2005 Soekris
>> Engineering. 
>>
>> net45xx
>>
>> 0064 Mbyte Memory                        CPU 80486 133 Mhz
>>
>> Pri Mas  SanDisk SDCFB-16                LBA 490-2-32  15 Mbyte
>>
>> Slot   Vend Dev  ClassRev Cmd  Stat CL LT HT  Base1    Base2   Int
>> -------------------------------------------------------------------
>> 0:00:0 1022 3000 06000000 0006 2280 00 00 00 00000000 00000000
>> 0:18:0 100B 0020 02000000 0107 0290 00 3F 00 0000E001 A0000000 10
>> 0:19:0 100B 0020 02000000 0107 0290 00 3F 00 0000E101 A0001000 11
>> 0:20:0 100B 0020 02000000 0107 0290 00 3F 00 0000E201 A0002000 05
>>
>>  1 Seconds to automatic boot.   Press Ctrl-P for entering Monitor.
>> Boot error
>>
>>     
>
> I have seen this before with my net4501's when I have flashed them to ComBIOS version 1.29.
>
> Enter into the comBIOS by hitting Ctrl-P. Type "show" and take a look at "BootDrive". 
>
> If it is not "80 81 F0 FF" type "Set BootDrive = 80 81 F0 FF" (That is eighty, eighty one, F zero,
FF) and reboot (just type reboot)
>
>
> _________________________________
> James W. McKeand
>
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>
>
>
>