Joe Lagreca wrote:
> I setup a third interface card in my m0n0wall, called OPT1.
> I want to put my trixbox on that OPT1 interface with NO NAT (trixbox
> and VOIP don't seem to play well with NAT).
> Here is the tricky part, the WAN interface connects via PPPOE to get
> its IP address and other network information. I initially tried to
> bridge OPT1 with the WAN, and then assign my trixbox one of their
> available IP's. The trixbox takes the IP address with no problems,
> however it won't take the gateway IP address (192.0.2.100), probably
> because its not on the same subnet as the IP address.
> Are their any other ways to get my trixbox working behind my m0n0wall
> without using NAT? I have 6 external IP's. Thanks!
Not sure how to fix your particular problem, but I can say I have a
Trixbox behind my m0n0wall on the LAN with NAT with absolutely no
problems. I don't even have any special ports open for it, just the
default LAN rule that allows any outbound.