Hi,

In message <1200070704 dot 3894 dot 50 dot camel at hoho2 dot chidig dot com>, Bob Gustafson
<bobgus at rcn dot com> writes
>I need to be able to set the Ethernet MAC addresses (clone..) on an Alix
>board (VIA VT6105M)
>
>Are these addresses hardware set, or can they be easily (??) changed via
>software?

If it's the WAN MAC address you need to set then you can do it through
the web frontend - under Interfaces | WAN | MAC address.

If it's any of the others then you'll need to do it in config.xml
(adding a 'spoofmac' section to each interfaace), the notes at:

http://wiki.m0n0.ch/wikka.php?wakka=NokiaBoxesSpoofMac

should show you the syntax.

HTH,


                                Neil.

-- 
Neil A. Hillard                E-Mail:   m0n0 at dana dot org dot uk