1) Yes the firewall rule was added automatically to allow to pass anything
to the 192.168.1.100 ip

2) I have no ideas what's the default gateway configuration on the switch :(

3) If there any way to setup DMZ for switch so I can get access to it and
check default gateway settings?


-----Original Message-----
From: Lee Sharp [mailto:leesharp at hal dash pc dot org] 
Sent: Thursday, January 24, 2008 11:07 AM
To: Monowall Support List
Subject: Re: [m0n0wall] PORT Fowarding Doenst Work?

Alex M wrote:
> Hey all, I feeling dummy here but I cant setup port forwarding that work
:-(
> 
> Here is what I have:
> 
> 1)       Mono Box connected directly to the net
> 
> 2)       Managed switch behind the mono
> 
>  
> 
> I want to access managed switch from remote location. I have seted up the
> firewall rule to allow my remote comp to connect to the mono box (Pass
FROM
> REMOTE_IP  to LAN on * PORT to * IP) So I type my wan IP on remte site and
I
> can get to the mono box no problem
> 
>  
> 
> Now I go to NAT port forwarding and seting up forwarding to my managd
> switch. Lets say my switch IP is 192.268.1.100 and port 80. So the rule
that
> I have seted up is:
> 
>  
> 
> Interface: WAN
> 
> EXT IP: ANY
> 
> Ext PORT: 8080
> 
>  
> 
> NAT IP: 192.268.1.100
> 
> NAT Port: 80
> 
>  
> 
> TCP/UDP
> 
>  
> 
>  
> 
> Well unfortunately that doesn't work and nothing gets forwarded :-( any
> ideas what did I do wrong?

Is the firewall rule on the WAN port allowing anything to 192.168.1.100 
on port 80?

---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch