just edit the saved xml configuration and change the interfaces before
you upload it, then you should be all set. note make sure you edit all
instances on the interfaces

On Mon, 2008-01-28 at 14:19 +0100, YvesDM wrote:
> On Jan 28, 2008 1:39 PM, <lutz dot niederer at gmx dot net> wrote:
> 
> > Hi,
> >
> > I would like to switch from wrap.1e to alix2c3.  The 1.3b9 beta should run
> > on the alix board.  But how do I migrate my configuration?
> > I would like to put the FW on the CF card, do the initial setup and after
> > that I would like to upload my old warp config file.  After that the new
> > alix should look exactly like the old wrap.  Am I dreaming or is that the
> > way to migrate from old to new hardware?
> >
> > Thanks for your help!
> > -lutzn
> 
> 
> You will probably just have to re-configure the interfaces again after
> you've uploaded your config.xml.
> The rest will be fine.
> 
> 
> 
> Kind regards
> Y.