Thanks!  But what should I edit into what exactly?



-------- Original-Nachricht --------
> Datum: Tue, 29 Jan 2008 05:28:02 +0800
> Von: OutBackDingo <outbackdingo at gmail dot com>
> An: YvesDM <ydmlog at gmail dot com>
> CC: m0n0wall at lists dot m0n0 dot ch
> Betreff: Re: [m0n0wall] Switching to alix2c3 from wrap.1e

> just edit the saved xml configuration and change the interfaces before
> you upload it, then you should be all set. note make sure you edit all
> instances on the interfaces
> 
> On Mon, 2008-01-28 at 14:19 +0100, YvesDM wrote:
> > On Jan 28, 2008 1:39 PM, <lutz dot niederer at gmx dot net> wrote:
> > 
> > > Hi,
> > >
> > > I would like to switch from wrap.1e to alix2c3.  The 1.3b9 beta should
> run
> > > on the alix board.  But how do I migrate my configuration?
> > > I would like to put the FW on the CF card, do the initial setup and
> after
> > > that I would like to upload my old warp config file.  After that the
> new
> > > alix should look exactly like the old wrap.  Am I dreaming or is that
> the
> > > way to migrate from old to new hardware?
> > >
> > > Thanks for your help!
> > > -lutzn
> > 
> > 
> > You will probably just have to re-configure the interfaces again after
> > you've uploaded your config.xml.
> > The rest will be fine.
> > 
> > 
> > 
> > Kind regards
> > Y.
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch

-- 
Der GMX SmartSurfer hilft bis zu 70% Ihrer Onlinekosten zu sparen! 
Ideal für Modem und ISDN: http://www.gmx.net/de/go/smartsurfer