I believe wrap interfaces are sis and alix are vr ??
so any references to sis0/sis1/sis2 should be changed to vr0/vr1/vr2 in
the XML config

On Mon, 2008-01-28 at 14:30 +0100, lutz dot niederer at gmx dot net wrote:
> 
> Thanks!  But what should I edit into what exactly?
> 
> 
> 
> -------- Original-Nachricht --------
> > Datum: Tue, 29 Jan 2008 05:28:02 +0800
> > Von: OutBackDingo <outbackdingo at gmail dot com>
> > An: YvesDM <ydmlog at gmail dot com>
> > CC: m0n0wall at lists dot m0n0 dot ch
> > Betreff: Re: [m0n0wall] Switching to alix2c3 from wrap.1e
> 
> > just edit the saved xml configuration and change the interfaces before
> > you upload it, then you should be all set. note make sure you edit all
> > instances on the interfaces
> > 
> > On Mon, 2008-01-28 at 14:19 +0100, YvesDM wrote:
> > > On Jan 28, 2008 1:39 PM, <lutz dot niederer at gmx dot net> wrote:
> > > 
> > > > Hi,
> > > >
> > > > I would like to switch from wrap.1e to alix2c3.  The 1.3b9 beta should
> > run
> > > > on the alix board.  But how do I migrate my configuration?
> > > > I would like to put the FW on the CF card, do the initial setup and
> > after
> > > > that I would like to upload my old warp config file.  After that the
> > new
> > > > alix should look exactly like the old wrap.  Am I dreaming or is that
> > the
> > > > way to migrate from old to new hardware?
> > > >
> > > > Thanks for your help!
> > > > -lutzn
> > > 
> > > 
> > > You will probably just have to re-configure the interfaces again after
> > > you've uploaded your config.xml.
> > > The rest will be fine.
> > > 
> > > 
> > > 
> > > Kind regards
> > > Y.
> > 
> > 
> > ---------------------------------------------------------------------
> > To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> > For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>