The command to disable the logging of wrong interface arp replies is

systcl net.link.ether.inet.log_arp_wrong_iface=0

Thanks,
Adam


Adam Piasecki wrote:
> Well, there is a point in doing it,  I can't assign a secondary IP 
> address's in m0n0wall(LAN SIDE). The only way around this was to use 
> another NIC card.
>
> The other problem i have, is that not all my devices are capable of 
> generating VLAN tags. So I'm forced to but both management traffic and 
> user traffic on the same switch.
>
> I don't really have a problem with this, as my users would have to 
> poke around a little bit to even find the management address range, 
> and all my boxes are password protected.
>
> I'll look into the sysctl command,
>
> thanks,
> Adam
>
> Chris Buechler wrote:
>> On Mon, Apr 7, 2008 at 5:17 PM, Wayne Fiori <dev9null at gmail dot com> wrote:
>>  
>>> Put the two networks on different VLANs if you need to keep both
>>>  interfaces connect to the same switch.
>>>
>>>     
>>
>> Yeah, ideally you never want two interfaces plugged into the same
>> switch like that. There isn't any point in doing so, and it's
>> considered bad network design.
>>
>> There's a sysctl to silence the ARP warnings. I don't recall offhand
>> if m0n0wall has a check box to accommodate that or not, check the
>> Advanced page, it might be there. Otherwise google on that error
>> message and you'll find the appropriate sysctl to turn it off.
>>
>> If you have a reason to use two interfaces like that, you should use
>> two switches, or VLANs.
>>
>> -Chris
>>
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
>> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>>
>>
>>
>>
>>   
>