If you have an assigned range and you can run native IPv6 over PPPoE you
need to configure the IPv6 statically on WAN and LAN.

Daniele

Nick Shore wrote:
>
>
> I tried out 1.3b13pre on a WRAP last night.
>
> I configured WAN as PPPOE and successfully used 6to4 on both WAN and
> LAN, with RA correctly working.
>
> I couldn't work out how to configure for PPPOE using my IPv6 range which
> my ISP has allocated.
>
> One of the issues may be that IPV6CP needs to be enabled on mpd (set
> bundle enable ipv6cp)
>
>
> Any hints ?
>
> Nick.
>
> PS. think there is an issue with the config file in 1.3b13-pre, a fresh
> install complained about syntax error in XML. An upgrade from 1.3b12
> worked fine.
>
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>
>
> --
> This message has been scanned for viruses and
> dangerous content by MailGate, and is
> believed to be clean.
>



-- 
This message has been scanned for viruses and
dangerous content by MailGate, and is
believed to be clean.