[ previous ] [ next ] [ threads ]
 
 From:  "Mohammed" <m dot ismael at gmail dot com>
 To:  <m0n0wall at lists dot m0n0 dot ch>
 Subject:  FW: [m0n0wall] help me!!
 Date:  Wed, 30 Jul 2008 17:50:34 +0300
It is very helpfull.
I am gonna test it right away.
This means that i can use dynamic dns built in m0n0wall
In short i could use m0n0wall services better.
And so for project Observer and m0n0wall CMI to accomplish connection to
m0n0wall embded PCs.
Thanks allot Rene

Mohammed. 


-----Original Message-----
From: Rene Moser [mailto:mail at renemoser dot net] 
Sent: Tuesday, July 29, 2008 3:24 PM
To: m0n0wall at lists dot m0n0 dot ch
Subject: Re: [m0n0wall] help me!!

hi

Mohammed wrote:
>> Another solution might be, if you would set your modem/router in bridge
>> mode and let mono does the PPPoe
>>
> Is that mean that the ADSL router/modem will communicate with VCI VPI
Values
> with no IP Addresses? And m0n0wall WAN interface will be assigned the
Public
> IP address from the ISP?
right, m0n0 uses the external IP from ISP on WAN.

> In another way, the Eth0 interface in my router/modem, which ip will be
> assigned to it?
a local area IP, i have a 192.168.123.0/24 networt, so my modem have 
usually 192.168.123.2.

But you won't have access to that router in normal usage, because it is 
outside your wan port. In bridge mode, everything that comes from dsl 
port goes directly to the ethernet port. the router is invisible...

If you need access to it, you plug it into your LAN switch and or you 
use a crosswired patch cable directly connected to your PC and browse to 
192.168.123.2.

of course you can also use a serial cable to access to the modem...

what is important: PPPoE must be configured on m0n0! the modem is not 
able to do this in bridge mode.

hope that helps

rm
signature.asc (0.3 KB, application/pgp-signature)