On Mon, Oct 13, 2008 at 09:09:43AM +0200, Manuel Kasper wrote:
> Hello Rudi,
> 
> On Oct 13, 2008, at 8:28 AM, Rudi van Drunen wrote:
> 
> >I assume that I have to defline the subnet (prefix) somewhere
> >(where ?) an then with the LAN interface on 6to4 and autoconfig
> >on all should be automagically work. But it does NOT.
> 
> The 6to4 setting on LAN only makes sense if you're using 6to4 on WAN  
> as well - but since you're using SixXS, you don't need 6to4.
> 
> Assuming that you have a /48 routed to you from SixXS, all you need to  
> do is:
> 
> - enable IPv6 support on the advanced setup page (obviously ;)
> 
> - choose IPv6 mode: AICCU on the WAN setup page and enter your SixXS  
> username/password/tunnel ID
> 
> - choose a /64 out of your allocated /48, set up the LAN interface  
> with a static IPv6 address out of that /64, and check the RA box
> 
> That's all - no static routes etc. necessary. In fact, that's exactly  
> the scenario I've used when testing the AICCU support in m0n0wall, and  
> for me it worked without any problems.

Manuel, (hi there, long time no see :) )

Got it running now, issue was that I was trying to put a
static from the /48 with the /48 mask onto the LAN.
No selected a /64 from the /48 outfrom sixxs, then put that 
onto the LAN with the /64 mask.

Got all riunning now, the turtle is dancing....

Rudi