I have the soekris lan port goes to a dell POE switch port  24 then I
have 5 AP's connected to port 1 thru 5.   

Users connect via wireless to LAN . Monowall is the dhcp server. 

I monitor all devices via snmp and access via web doing port forwarding.

I tried also replacing the switch but it work for a while then start
happening again.  I use to have a soekris 4801 so I also replace that
one with the bigger one just in case but still happening.


Let me know if you need something else,

Thank you,

Jessica

-----Original Message-----
From: Lee Sharp [mailto:leesharp at hal dash pc dot org] 
Sent: Wednesday, July 01, 2009 10:49 AM
To: m0n0wall at lists dot m0n0 dot ch
Subject: Re: [m0n0wall] ARP errors

Jessica Aguilar wrote:
> Hello Support
> 
>  
> 
> I am experiencing some problems with my infrastructure.   Basically
for
> some reason all the devices stop sending traffic.   Let me explain my
> config. I have the soekris then a have a poe switch and then I have
some
> AP's.  I am monitoring all of those devices thru SNMPC program.    But
> for some reason  devices stop responding  but I always have access to
> soekris. If I check the ARP table there is nothing in there.
> 
>  
> 
> I thought it was the equipments so I reboot them no luck.  So I what I
> do is reboot soekris and everything start responding again.   I have
the
> latest firmware and sokeris net5501 . 

I need to know some more about your topography.  On the LAN side, you 
have 1 switch, and some APs, only? (And obviously clients, but no other 
switches)  How many APs.  Is the SNMP system on that interface?  How is 
it connected?  How are you connected?

I have had a few issues like this come up lately.  All were bad
switches.

			Lee

---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch