On 4 February 2010 12:40, Dennis Karlsson <dennis at denniskarlsson dot com> wrote:
> *1. Enable advanced outbound NAT
I've tried that. I assume I need to create a mapping for my internal
subnet in the section below
where this is enabled?

> **2. Disable port mapping*
I don't have any NAT rules defined which would affect the xbox.

Thanks

Mike



> *
> *
> On 2010-02-04 13:05, Mike Dent wrote:
>>
>> Hi,
>> I've been using m0n0wall for several years now. Most recently I was on
>> 1.2(something). My two lads who both use XBOX 360 reported that NAT
>> was showing
>> as 'moderate' from their xboxes. This usually does not cause a problem.
>>
>> However recently I upgraded to m0n0wall 1.3 and now NAT shows as strict?
>>
>> I can't see any changes in the config that may have caused this to happen.
>> I realise that m0n0 does not support upnp for good reason but if I
>> could get things working
>> back as how it was, ie moderate nat, then I would be happy.
>>
>> Many thanks
>>
>> Mike
>>
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
>> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>>
>>
>