Lee Sharp wrote on Fri, Jul 16 2010 at 11:18 am:
> For the record, NAT breaks a lot of stuff. That said, we have an
> amazing amount of control in how NAT works on m0n0wall. What he is
> telling you is that you can configure NAT so that it is turned off for
> the bridged interface. This can be a bit complex to set up right, which
> is why it is in the "Advanced Outbound NAT" section.
Ah, OK. We'd only intended to use NAT on the LAN anyway so that's fine. It sounds from the docs
that, in 1.3, Advanced Outbound NAT is pretty much automatic.
- Steve Yates
- ITS, Inc.
- Ah... aah... aaah... atchouw2XO1:4,&bKx NO CARRIER
~ Taglines by Taglinator: www.srtware.com ~