Hi Barry,

On Tue, 2004-02-24 at 07:36, Barry Murphy wrote:
> Hi,
> 
> Is it possible to enable both http and https for debug purposes. The
> last time I loaded a cert into m0n0wall it didn't boot up, this ment I
> had to go to the customers site, climb in the roof, pull it down, take
> it home and reconfigure the LAN IP, then put it back.
> 
> It would be nice if you could turn on https and have http as a failsafe.

That would kind of make the https access method useless - you can get
around it by using the insecure http protocol.

> I'm a bit scared of putting my signed (cacert.org) cert into m0n0wall
> again.

Try it on a test box first.

-- 

Regards,

Hilton Travis                   Phone: +61-(0)7-3343-3889
Manager, Quark AudioVisual      Phone: +61-(0)419-792-394
         Quark Computers         http://www.QuarkAV.com/
(Brisbane, Australia)            http://www.QuarkAV.net/

Open Source Projects:		http://www.ares-desktop.org/
				http://www.mamboband.org/

Non Linear Video Editing Solutions & Digital Audio Workstations
 Network Administration, SmoothWall Firewalls, NOD32 AntiVirus
  Conference and Seminar AudioVisual Production and Recording

War doesn't determine who is right. War determines who is left.