[ previous ] [ next ] [ threads ]
 From:  Sam Kretchmer <skretch at rootaxcess dot com>
 To:  Lee Sharp <leesharp at hal dash pc dot org>, "m0n0wall at lists dot m0n0 dot ch" <m0n0wall at lists dot m0n0 dot ch>
 Subject:  Re: [m0n0wall] PPTP/IPSEC clients
 Date:  Fri, 11 Apr 2014 13:25:12 +0000

So the ³Server address² is the internal IP the PPTP server daemon uses?
Then clients coming in NAT to an IP in the range allowed, and use the
³Server address² in their local routing table as the next-hop for the
remote network?

I also was wondering about the 'IPSEC‹>Mobile clients‹>My Identifier'
field. How do you use this to set up multiple users? I have the multiple
users specified with individual Pre-share keys on the Pre-share key tab,
but I can only enter one user in the ³My identifier² field. How does one
specify multiple users?



On 4/11/14, 7:30 AM, "Lee Sharp" <leesharp at hal dash pc dot org> wrote:

>On 04/11/2014 06:44 AM, Sam Kretchmer wrote:
>> Hi all,
>> I was wondering if anyone has run into this, or knows what's going on.
>> I am trying to set up a PPTP VPN server on m0n0wall 1.8.
>> Can I have both IPSEC and PPTP clients at the same time?
>> If I give the PPTP server it's own IP, it will not respond to clients
>>on that IP. I have to use the primary IP for clients to connect to, but
>>the client then shows the connection to the secondary IP once connected.
>> What is the purpose of the IP Address field on the PPTP configuration
>> So, at the moment, I have a server with IP I have given the
>>PPTP server page an IP of Clients CAN connect to, but
>>clients CAN NOT connect to
>This is how it is supposed to work.  The IP address and range are IPs
>for once you are connected.  The System IPs are how you connect.
>			Lee
>To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
>For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch