Yes you can, the way I did it was that I created an inbound NAT rule
that port forwarded port 80 to internal LAN IP address of M0N0Wall. Now
I am not sure about the https though.

Joe

-----Original Message-----
From: Federico Krum [mailto:federico at thehost dot com dot ar] 
Sent: Sunday, August 24, 2003 10:22 PM
To: m0n0wall at lists dot m0n0 dot ch
Subject: [m0n0wall] GUI from the WAN

I know it is not secure...but.... can I make the GUI available to the
WAN ?
Is there a way to run it under HTTPS ?

Thx