Sorry.....is working ok !!! my mistake !!


> It worked !!!
> Everything went smooth and worked, till I tried to change the default
> forwarding (80 to 80) from the wan for 12345 to 80.
> I have made the changes in both...The NAT rule and  the firewall rule
> automaticaly made by NAT without success.
> Any clue?
> 
> Thanx
> ----- Original Message ----- 
> From: "Joe Doran" <joe at jbdww dot com>
> To: <m0n0wall at lists dot m0n0 dot ch>
> Sent: Monday, August 25, 2003 10:09 AM
> Subject: RE: [m0n0wall] GUI from the WAN
> 
> 
> > Yes you can, the way I did it was that I created an inbound NAT rule
> > that port forwarded port 80 to internal LAN IP address of M0N0Wall. Now
> > I am not sure about the https though.
> >
> > Joe
> >
> > -----Original Message-----
> > From: Federico Krum [mailto:federico at thehost dot com dot ar]
> > Sent: Sunday, August 24, 2003 10:22 PM
> > To: m0n0wall at lists dot m0n0 dot ch
> > Subject: [m0n0wall] GUI from the WAN
> >
> > I know it is not secure...but.... can I make the GUI available to the
> > WAN ?
> > Is there a way to run it under HTTPS ?
> >
> > Thx
> >
> >
> > ---------------------------------------------------------------------
> > To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> > For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
> >
> >
> >
> 
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
> 
>