:) Adam, lol

Juan, I bet this is the problem, m0n0 sees the two nics you have and wants
to assign them to LAN and WAN. It looks from the picture that your board
only has one RJ45 port on it. Manual may have to do something about this.

Dave

-----Original Message-----
From: Juan Garcia [mailto:juangarcia at sacbeemail dot com] 
Sent: Friday, April 02, 2004 6:36 PM
To: adam at nellemann dot nu; juan garcia
Cc: m0n0wall at lists dot m0n0 dot ch
Subject: Re: Re: [m0n0wall] Where is the SSID???


My bad.  It is not a Soekriss board.  It is made by teletronics.  

Number on board is AQS0227

picture at www.florencia.us/myboard1.jpg and www.florencia.us/myboard1.jpg

jg

>Erhm, I might be mistaken, but to my knowledge, Soekriss Engineering 
>has never made a board with less than two 10/100 interfaces (ie.
>sis0 and sis1), so unless you actually have such a board(?), it really 
>MUST be some problem with your sis1 interface, probably one of the 
>issues


Composed by sacbeemail.
Get Your Free E-mail at http://www.sacbeemail.com . Or visit Northern
California's premiere news and information website at http://www.sacbee.com
.

---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch