The way I did mine is:

Assign an0 to the WAN.
Assign sis0 to the LAN.
Reboot.
Click on LAN and setup the IP, ...
Click on WAN and set up the IP, SSID, Channel, ...
Click on Rules, setup the firewall.
Reboot.
Backup config.
Done.

On the WAN, LAN, or OPTx screens you should have a "Wireless 
configuration" heading.  It should have under it Mode, SSID, Channel, 
Station name, and WEP.  If it does not, there there is something wrong 
with m0n0.

On Apr 1, 2004, at 11:29 PM, Juan Garcia wrote:

> I have a soakris board with a cisco aironet 350 pcmcia card.  I am
> booting monowall from a CF.  My problem is I cannot find the location
> where I can set up the wireless parameters.  I have both console and
> http access to the box but I cannot find anything for the life of me.
>
> On the gui I see
> ...
> Interfaces (assign)
>   LAN
>   WAN
> ...
> but nothing about my wireless card.
>
> On the console I see no way of assigning anything to OPT1.  I can
> assign an interface to LAN (sis0) and to WAN (an0) but that is it.
>
> Any help is appreciated.
>
> jg
>
>
> Composed by sacbeemail.
> Get Your Free E-mail at http://www.sacbeemail.com . Or visit Northern 
> California’s premiere news and information website at 
> http://www.sacbee.com .
>
> --cegiojimlhkoildakbgf
> Content-Type: message/rfc822
> Content-Disposition: inline; filename="m0n0wall_4653.ezm"
>