Fixed, sorry guys...

card "INTERSIL" "HFA384x/IEEE"
        config  auto "wi0" ?
        config  auto "wi1" ?

Was only set for one device in pccard.conf

Barry

-----Original Message-----
From: Ross Bateman [mailto:r dot bateman at workmanufacturing dot com] 
Sent: Wednesday, 28 April 2004 8:48 p.m.
To: m0n0wall Mailing List
Subject: [m0n0wall] Public Addresses inside and out


Hi

I currently have a full C-Class IP range.

Is there a way to run m0n0 with a public address on both the LAN and WAN
sides? This will allow me to install the firewall without to much hassle
and then give me time to implement a change over of my internal
addresses to 'fake' addresses.

If this is possible and once m0n0 is in place, what pitfalls should I
watch out for until such time as I can switch all the machines on the
inside to 'fake' IPs?

Thanks,

Ross


---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch