[ previous ] [ next ] [ threads ]
 
 From:  "Holger Goetz" <holgerg at hgsys dot de>
 To:  "m0n0wall at lists dot m0n0 dot ch" <m0n0wall at lists dot m0n0 dot ch>
 Subject:  Re: [m0n0wall] RE: Problem with PCMCIA Cards
 Date:  Fri, 07 May 2004 12:06:53 +0200
Hi,

did anybody get back to this and gave any further info?
Non of my "supported" cards is recognised as well...

Thanks
Holger



On Wed, 05 May 2004 17:29:10 -0600, Christian van Eeden  
<christian at vaneeden dot ca> wrote:

> I have found this:
> -----------------------------
> From :   	"M. G. (Michael) de Bruin" <mg dot debruin at buum dot
> nl>
> Subject :  	Re: [m0n0wall] PCMCIA Ethernet cards not supported?
>
> What you could do pretty simple, is add the standard pccard.conf from a
> FreeBSD install. You could either do this on-the-fly with exec.php and
> then killing the pccard daemon, or you could build it into the image
> itself.
>
> For your comfort, I've put the /etc/default/pccard.conf for a standard
> 4.9-RELEASE online at http://dwaalspoor.org/pccard.conf.
> ------------------------------
>
> Since I can't get remotely onto the machine (both NICs are not working)
> I can't use exec.php. And I am not sure how to rebuild the image.
> Are there instructions? I am using the generic-pc-1.0.
> Is there someone out there who can build an image with the updated
> pccard.conf without too much trouble? They can e-mail it too me (my box
> is unlimited) and I can host the file for anyone else.
>
> Thanks in advance,
>
> Christian van Eeden
> Technical Director
> Infinite Bang Communications
>
> -----Original Message-----
> From: Christian van Eeden [mailto:christian at vaneeden dot ca]
> Sent: Wednesday, May 05, 2004 3:47 PM
> To: 'm0n0wall at lists dot m0n0 dot ch'
> Subject: Problem with PCMCIA Cards
>
> I have an IBM 365XD with two "Xircom CreditCard 10Base-T ``CreditCard
> Ethernet Adapter IIps'' (PS-CE2-10)" cards. According to the FreeBSD
> Hardware Compatibility Guide, they are supported, however when I boot
> m0n0wall, and hookup the cards to the network, there is no link light on
> either card.
> From boot message I can see that the PC Card slots are being detected,
> and that it says there are cards present on pcic0. However when it tries
> to "Starting PC Cards..." it does don't detect anything (not sure if
> this is normal). After boot is complete LAN -> sis0 and WAN -> sis1, and
> if I try to re-assign it to xe0 or xe1 it says it's an Invalid
> interface.
>
> Any ideas?
>
> Christian van Eeden
> Technical Director
> Infinite Bang Communications
>
>
>
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>