Hi again,
Yes, the filesystem is UFS (sometimes referred to as FFS). Try both, if 
you have support for them in your kernel it should work.

--
Thomas Hertz


Chris Bond wrote:

>Just tried mount -o loop -t minix /home/chris/generic-pc-pb15r497.img
>/mnt/flash and it didn't work any idea what the filesystem type is?
>
>-----Original Message-----
>From: Thomas Hertz [mailto:thomas at hz dot se] 
>Sent: 25 September 2003 4:16 PM
>To: m0n0wall at lists dot m0n0 dot ch
>Subject: Re: [m0n0wall] M0n0wall PC Image fails to work
>
>Just mount the image loopback, and edit /etc/fstab and change all 
>occurances of "ad0a" to "ad2a".
>In *BSD you use the "vnconfig" command, and in linux "mount -o 
>generic-pc-pb15r497.img /mnt".
>
>--
>Thomas Hertz
>
>
>Chris Bond wrote:
>
>  
>
>>Just installed the PC Image on a compactflash.  It boots you get the kernel
>>loading etc but you get the following messages on boot and consequently you
>>can not run assign ip or any of the first 2-3 options on the console screen
>>nor is 192.168.1.1 pingable.
>>
>>Mount root from uds /dev/md0c
>>Mount /dev/ad0a: Device not configured
>>
>>Warning: fopen(conf/config.xml): failed to open stream: No such file or
>>directory in /etc/inc/xmlparse.inc on line 123
>>
>>Is there anyway to fix this?  Its running on the linux eqvil of /dev/hdc -
>>cant change this as it's a lex light board.
>>
>>Kind Regards,
>>Chris Bond
>>
>>
>>---------------------------------------------------------------------
>>To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
>>For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>>
>> 
>>
>>    
>>
>
>
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
>For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>
>
>  
>