I got m0n0wall net48xx-1.0.img loaded on my CF card using physdiskwrite
0.4. The card then went directly into the Soekris net4801. Following is
the result (sorry - much of this is probably superfluous, but thought
too much was better than not enough).
Ideas???
Thnx,
Jay
comBIOS ver. 1.24 20040312 Copyright (C) 2000-2004 Soekris
Engineering.
net4801
0128 Mbyte Memory CPU Geode 266 Mhz
Pri Mas SanDisk SDCFH-1024 LBA Xlt 993-32-63 1001 Mbyte
PXE-M00: BootManage UNDI, PXE-2.0 (build 082)
Slot Vend Dev ClassRev Cmd Stat CL LT HT Base1 Base2 Int
-------------------------------------------------------------------
0:00:0 1078 0001 06000000 0107 0280 00 00 00 00000000 00000000 00
0:06:0 100B 0020 02000000 0107 0290 00 3F 00 0000E101 A0000000 10
0:07:0 100B 0020 02000000 0107 0280 00 3F 00 0000E201 A0001000 10
0:08:0 100B 0020 02000000 0107 0290 00 3F 00 0000E301 A0002000 10
0:18:2 100B 0502 01018001 0005 0280 00 00 00 00000000 00000000 00
0:19:0 0E11 A0F8 0C031008 0117 0280 08 38 00 A0003000 00000000 11
1 Seconds to automatic boot. Press Ctrl-P for entering Monitor.
Console: internal video/keyboard
BIOS drive C: is disk0
BIOS 639kB/130048kB available memory
FreeBSD/i386 bootstrap loader, Revision 0.8
(root at nb dot neon1 dot net, Mon Jul 28 20:31:49 CEST 2003)
/kernel text=0x198300 data=0x23d14+0x1c790
syms=[0x4+0x2a720+0x4+0x315fa]
Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [kernel]...
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights
reserved.
FreeBSD 4.9-RELEASE-p1 #0: Wed Jan 21 19:59:22 CET 2004
root at nb dot neon1 dot net:/usr/src/sys/compile/M0N0WALL_NET48XX
Timecounter "i8254" frequency 1193182 Hz
CPU: NSC Geode (266.65-MHz 586-class CPU)
Origin = "Geode by NSC" Id = 0x540 Stepping = 0 DIR=0x81b7
Features=0x808131<FPU,TSC,MSR,CX8,CMOV,MMX>
real memory = 134217728 (131072K bytes)
avail memory = 116944896 (114204K bytes)
Preloaded elf kernel "kernel" at 0xc0d37000.
Preloaded mfs_root "/mfsroot" at 0xc0d3709c.
md0: Preloaded image </mfsroot> 10485760 bytes at 0xc03354c8
md1: Malloc disk
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
sis0: <NatSemi DP83815 10/100BaseTX> port 0xe100-0xe1ff mem
0xa0000000-0xa0000ff
f irq 10 at device 6.0 on pci0
sis0: Ethernet address: 00:00:f4:2c:49:73
miibus0: <MII bus> on sis0
ukphy0: <Generic IEEE 802.3u media interface> on miibus0
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
sis1: <NatSemi DP83815 10/100BaseTX> port 0xe200-0xe2ff mem
0xa0001000-0xa0001ff
f irq 10 at device 7.0 on pci0
sis1: Ethernet address: 00:00:f4:c2:87:87
miibus1: <MII bus> on sis1
ukphy1: <Generic IEEE 802.3u media interface> on miibus1
ukphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
sis2: <NatSemi DP83815 10/100BaseTX> port 0xe300-0xe3ff mem
0xa0002000-0xa0002ff
f irq 10 at device 8.0 on pci0
sis2: Ethernet address: 00:00:f4:bc:49:33
miibus2: <MII bus> on sis2
ukphy2: <Generic IEEE 802.3u media interface> on miibus2
ukphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
isab0: <PCI to ISA bridge (vendor=100b device=0510)> port
0x6200-0x623f,0x6100-0
x613f at device 18.0 on pci0
isa0: <ISA bus> on isab0
chip1: <PCI to Other bridge (vendor=100b device=0511)> port
0x6300-0x63ff at dev
ice 18.1 on pci0
atapci0: <Generic PCI ATA controller> port 0xe000-0xe00f at device 18.2
on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
chip2: <PCI to Other bridge (vendor=100b device=0515)> port
0x6500-0x653f at dev
ice 18.5 on pci0
ohci0: <OHCI (generic) USB controller> mem 0xa0003000-0xa0003fff irq 11
at devic
e 19.0 on pci0
usb0: OHCI version 1.0, legacy support
usb0: <OHCI (generic) USB controller> on ohci0
usb0: USB revision 1.0
uhub0: (0x0e11) OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 3 ports with 3 removable, self powered
orm0: <Option ROM> at iomem 0xc8000-0xd1fff on isa0
pmtimer0 on isa0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x30 on isa0
sio0: type 16550A, console
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
BRIDGE 020214 loaded
IPsec: Initialized Security Association Processing.
IP Filter: v3.4.31 initialized. Default = block all, Logging = enabled
ad0: READ command timeout tag=0 serv=0 - resetting
ata0: resetting devices .. done
ad0: 977MB <SanDisk SDCFH-1024> [1986/16/63] at ata0-master WDMA2
ad0: READ command timeout tag=0 serv=0 - resetting
ata0: resetting devices .. done
ad0: READ command timeout tag=0 serv=0 - resetting
ata0: resetting devices .. done
ad0: READ command timeout tag=0 serv=0 - resetting
ad0: trying fallback to PIO mode
ata0: resetting devices .. done
Fatal trap 12: page fault while in kernel mode
fault virtual address = 0x7800ec
fault code = supervisor read, page not present
instruction pointer = 0x8:0xc0186f59
stack pointer = 0x10:0xc029b1e8
frame pointer = 0x10:0xc029b224
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = Idle
interrupt mask = bio
trap number = 12
panic: page fault | 