>
>> Chet suggested I upgrade the firmware in the senao card.

> I did the above, successfully installed senao drivers
> on my friend's system, upgraded to 1.7.4,
> Station and Primary (?)....

use 1.1.1 1.5.6 with freebsd 4.x

from freebsd 5.x 1.7.4 works,

monowall is 4.9

Marten





>
> I put cards in the soekris, pulled the plug, rebooted.  It does not work.
>
> The log says PRISM 1.07.04 - but it also reports
> 1.01.01 (one's for primary, one's for station).
> Is that an issue?
>
> From exec.php, ifconfig wi0 shows generic station id,
> no ssid, no IP address.
>
> ifconfig allows me to set some of these parameters
> and see the change accepted, but cannot communicate.
> No link detected, stations can't connect.
>
> Has anyone had experience with this?
> The wall is getting cracks in it...
>
> Thanks
> Seth
>
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>
>