|
||||||||
Hi Olivier, Believe me, we all ask questions like that at times, and then wonder how we coulf have been so <insert description of choice here>. :) I've done it before, and I'll no doubt do it again! -- Regards, Hilton Travis Phone: +61 (0)7 3343 3889 (Brisbane, Australia) Phone: +61 (0)419 792 394 Manager, Quark IT http://www.quarkit.com.au Quark AudioVisual http://www.quarkav.net http://www.threatcode.com/ <-- its now time to shame poor coders into writing code that is acceptable for use on today's networks War doesn't determine who is right. War determines who is left. > -----Original Message----- > From: Olivier Nibart [mailto:olivier at naya dash tec dot com] > Sent: Saturday, 3 July 2004 04:50 > To: m0n0wall at lists dot m0n0 dot ch > Subject: Re: [m0n0wall] IPSEC taking very long time to start > --> shame on me :((( > > Folks, > > I just understood that the IPSEC tunnel is smart enough to > start only when a packet need to be sended on it..... > How could I lived without knowing that ? o:)) > > I hope I made some of you laugh ans had good time, and some > other learn something ! > > Have a nice evening or day..... > > Olivier Nibart wrote: > > > Hi all, > > > > I've set up IPSEC between 2 monowalls and it works fine. > > However it sometimes take 20 minutes for the 2 boxes to start the > > IPSEC tunnel. > > Once started, everything is ok. > > > > The line itself works great (I manage the 'remote' > monowalll trough a > > citrix session at the same time without any problems). > > > > Does one of you have the same behavior ? I really do not figure out > > why this happens and didn't find any answer.... > > > > -- > olivier > --=ooOoo=-- > olivier at naya dash tec dot com (Olivier Nibart) > http://www.naya-tec.com > gsm: +32 472 514 103 > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch > For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch > > |