On Fri, 30 Jul 2004, Jon Tackabury wrote:

> This might be a silly question... but how do I create a rule that
> applies to an outbound connection?  When I create rules then check the

outgoing connections (from behind the m0n0wall) are enabled by default.

> status page it only creates "pass in" and "block in" rules.  Can I
> create "pass out" and "block out" rules as well, or is there a different
> way to handle this?

not in that manner. you could however create "pass/block in" rules on the
incoming interface, specifying the hosts/nets you're blocking using the
source address.

Regards,                           /\_/\   "All dogs go to heaven."
dinesh at alphaque dot com                (0 0)    http://www.alphaque.com/
+==========================----oOO--(_)--OOo----==========================+
| for a in past present future; do                                        |
|   for b in clients employers associates relatives neighbours pets; do   |
|   echo "The opinions here in no way reflect the opinions of my $a $b."  |
| done; done                                                              |
+=========================================================================+