Interesting...when did this start to occur just in 1.1? I run 1.1.b15 on a 
soekris with 2 senao cards both WEP and DHCP enabled and they are fine.

Something change in 1.1b16 or 17?


Chet Harvey
Pitbull Technologies <http://www.pittech.com/> 
Protecting your Digital Assets
703.407.7311


Quoting David Kitchens <spider at webweaver dot com>:

>  
> Turn off WEP and I bet you get DHCP, I just confirmed again on a fresh load
> of 1.1 that WEP is messing with DHCP. Personally, I don't know what it is
> that is causing it but I would be willing to do some testing if someone has
> some clues as to what to check.
> 
> Dave
> 
> > -----Original Message-----
> > From: Jim Berry [mailto:jberry at netranom dot com] 
> > Sent: Thursday, September 02, 2004 10:54 AM
> > To: m0n0wall at lists dot m0n0 dot ch
> > Subject: [m0n0wall] DHCP over wi0
> > 
> > Hello list,
> >   I cannot get DHCP to hand out addresses over the wireless 
> > link. (hostap mode) I'm using a WRAP board and senao card. It 
> > works great with statics, but no DHCP at all. I had seen a 
> > few questions about this before in the archives, but no 
> > answer. Has this been fixed in a newer release, or am I just 
> > doing something wrong.
> >  
> >   Thank you,
> >  
> >   Jim Berry
> > 
> 
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
> 
>