Can you provide the following commands?

sho run
sho vlan
sho int trunk  <-- not sure if this one will be available to you or not.

Also... what IOS are you running on that switch?

Thank you,
Jake Seitz - Founder
Agatestreet.com - Cleaning Inbox's one domain at a time!
http://www.agatestreet.com
d 1.866.850.1608
f 1.858.964.6461

-----Original Message-----
From: Daniele Guazzoni [mailto:daniele dot guazzoni at gcomm dot ch] 
Sent: Friday, September 03, 2004 6:01 PM
To: m0n0wall List
Subject: [m0n0wall] m0n0wall VLAN (fxp and Cisco Catalyst) problem

I've configured my m0n0wall to use VLAN on an fxp dual 100baseTX card.
Actually VLANs 101 to 104 are configured on fxp1.
The fxp1 port is connected to a Cisco Catalyst 2950.
The cat port is configured for 802.1q trunking and it sees the VLANs.

No traffic is passing from the m0n0wall to the VLANs on the Cat.

Any idea ?


regards


------------------------------------------------------------------

Daniele Guazzoni
Network & System Engineer
Cisco Certified Network Professional

------------------------------------------------------------------
"Destiny is not a matter of chance, it is a matter of choice;
it is not a thing to be waited for, it is a thing to be achieved."
                         William Jennings Bryan


---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch