|
||||||||
Allan you're right. I've really overseen this... The physical interface is automatically set to down as soon as you configure vlans. Is there a patch to release 1.1 ? Daniele Allan D. Piske wrote: > I don't know if that applies here, but since m0n0wall 1b16 ( when vlans > where introduced ) there is a but on the m0n0wall scripts that doesn't set > "UP" the interfaces ... > when you type ifconfig command on the exec php script ( > http://monowallip/exec.php ) you should see a UP flag on both fisical and > logical interfaces .. to test it just type ifconfig interface up on the same > exec script and see if it works ... > if yes, contact-me, i'll send instructions on howto fix it. > > bb, > > Allan. > zyryz at zyryz dot net > > ----- Original Message ----- > From: "Jake S" <jake at agatestreet dot com> > To: <daniele dot guazzoni at gcomm dot ch>; "'m0n0wall List'" <m0n0wall at lists dot m0n0 dot ch> > Sent: Saturday, September 04, 2004 12:18 PM > Subject: RE: [m0n0wall] m0n0wall VLAN (fxp and Cisco Catalyst) problem > > > >>Daniele, >>I will setup a test m0n0 wall here and let you know but from your > > interface > >>output it almost seems like there are no IP's assigned to vlan 100-104? >> >>$ ifconfig vlan1 >>vlan1: flags=8842<BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 >>ether 00:50:8b:5a:26:f6 >>media: Ethernet autoselect (100baseTX <full-duplex>) >>status: active >>vlan: 102 parent interface: fxp1 >> >>$ ifconfig vlan2 >>vlan2: flags=8842<BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 >>ether 00:50:8b:5a:26:f6 >>media: Ethernet autoselect (100baseTX <full-duplex>) >>status: active >>vlan: 103 parent interface: fxp1 >> >>$ ifconfig vlan3 >>vlan3: flags=8842<BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 >>ether 00:50:8b:5a:26:f6 >>media: Ethernet autoselect (100baseTX <full-duplex>) >>status: active >>vlan: 104 parent interface: fxp1 >> >> >>Other then that your switch config looks fine. >> >>Jake >> >>-----Original Message----- >>From: Daniele Guazzoni [mailto:daniele dot guazzoni at gcomm dot ch] >>Sent: Saturday, September 04, 2004 4:36 AM >>To: Jake S >>Subject: Re: [m0n0wall] m0n0wall VLAN (fxp and Cisco Catalyst) problem >> >>Jake >> >>It is a Cat 2950-24 with IOS 12.1.22 (c2950-i6q4l2-mz.121-22.EA1.bin). >>Attached you'll find the command results. >>I also tried to reduce the MTU to 1480 on the VLANs ( a tip I read >>somewhere on the web) which altough does not provide any help. >> >>Attached are the result of the commands on the cat and an ifconfig on >>the m0n0wall. >> >>Daniele >> >>Jake S wrote: >> >>>Can you provide the following commands? >>> >>>sho run >>>sho vlan >>>sho int trunk <-- not sure if this one will be available to you or not. >>> >>>Also... what IOS are you running on that switch? >>> >>>Thank you, >>>Jake Seitz - Founder >>>Agatestreet.com - Cleaning Inbox's one domain at a time! >>>http://www.agatestreet.com >>>d 1.866.850.1608 >>>f 1.858.964.6461 >>> >>>-----Original Message----- >>>From: Daniele Guazzoni [mailto:daniele dot guazzoni at gcomm dot ch] >>>Sent: Friday, September 03, 2004 6:01 PM >>>To: m0n0wall List >>>Subject: [m0n0wall] m0n0wall VLAN (fxp and Cisco Catalyst) problem >>> >>>I've configured my m0n0wall to use VLAN on an fxp dual 100baseTX card. >>>Actually VLANs 101 to 104 are configured on fxp1. >>>The fxp1 port is connected to a Cisco Catalyst 2950. >>>The cat port is configured for 802.1q trunking and it sees the VLANs. >>> >>>No traffic is passing from the m0n0wall to the VLANs on the Cat. >>> >>>Any idea ? >>> >>> >>>regards >>> >>> >>>------------------------------------------------------------------ >>> >>>Daniele Guazzoni >>>Network & System Engineer >>>Cisco Certified Network Professional >>> >>>------------------------------------------------------------------ >>>"Destiny is not a matter of chance, it is a matter of choice; >>>it is not a thing to be waited for, it is a thing to be achieved." >>> William Jennings Bryan >>> >>> >>>--------------------------------------------------------------------- >>>To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch >>>For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch >>> >> >> >>--------------------------------------------------------------------- >>To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch >>For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch >> >> >>Esta mensagem foi verificada pelo E-mail Protegido Terra. >>Scan engine: VirusScan / Atualizado em 01/09/2004 / Versão: 1.5.2 >>Proteja o seu e-mail Terra: http://www.emailprotegido.terra.com.br/ >> >>E-mail classificado pelo Identificador de Spam Inteligente Terra. >>Para alterar a categoria classificada, visite >> > > http://www.terra.com.br/centralunificada/emailprotegido/imail/imail.cgi?+_u=zyryz&_l=1,1094311213.659857.18991.conventos.terra.com.br,4693,Des15,Des15 > > > > --- > Outgoing mail is certified Virus Free. > Checked by AVG anti-virus system (http://www.grisoft.com). > Version: 6.0.746 / Virus Database: 498 - Release Date: 31/8/2004 |