[ previous ] [ next ] [ threads ]
 
 From:  "Adrian Padilla" <Adrianp918 at majesticsoundsonline dot com>
 To:  "Allan D. Piske" <zyryz at zyryz dot net>, "Jeff Lorenzini" <jlorenzini at stratacare dot com>, <m0n0wall at lists dot m0n0 dot ch>
 Subject:  RE: [m0n0wall] Can't get the web interface to work
 Date:  Tue, 21 Sep 2004 16:15:09 -0400
Yes I tried with only one interface and would not work I had to have 2 nic
cards then all went fine

 -----Original Message-----
From: 	Allan D. Piske [mailto:zyryz at terra dot com dot br]
Sent:	Tuesday, September 21, 2004 4:12 PM
To:	Jeff Lorenzini; m0n0wall at lists dot m0n0 dot ch
Subject:	Re: [m0n0wall] Can't get the web interface to work

I'm not pretty sure about that but i think that m0n0wall needs at least 2
interfaces configured:
Lan and Wan.

make sure the two of them are assigned and are on diferent logical subnets.
Also, try load default config on m0n0 console and try only to assign the
interfaces without changing addresses.
Try to connect a PC on LAN interface using DHCP then try access the webgui
again ( use the crossover cable )

If it still doesnt work you have some serious problem, belive me, it should
work that way.


Regards,

Allan
zyryz at zyryz dot net


----- Original Message -----
From: "Jeff Lorenzini" <jlorenzini at stratacare dot com>
To: <m0n0wall at lists dot m0n0 dot ch>
Sent: Tuesday, September 21, 2004 4:47 PM
Subject: [m0n0wall] Can't get the web interface to work


Hi,

I downloaded and installed the latest CD-ROM version of m0n0wall, but I
was pretty much hosed right from the start.

I specified my LAN card, set the subnet mask, assigned an IP, but when I
try and bring up the web interface from another machine it doesn't
respond. Also, ping shows no response.

I've got a straightforward LAN, all on 192.168.0.x with 255.255.255.0
subnet. FreeBSD recognizes the LAN adapters (I've tried three different
ones), shows (up) by the LAN adapter even. But no web interface. I'm
going to http://192.168.0.3/ to bring it up, in my specific case.
Automatic configuration fails, though.

Anybody have any ideas? I've tried m0n0wall on two machines and three
adapters, as well as two different 10/100/1000 switches, so I'm pretty
much giving up at this point.

Maybe I'll try running a crossover between a machine and the m0n0wall
computer, to see if I can access it that way. Other than that, I'm
stumped.

Thanks,

_/eff lorenzini
a certified industry figure since 1996
http://www.jeffcertified.com




---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.756 / Virus Database: 506 - Release Date: 8/9/2004


---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch